///PAY TV DECODER PLANS///         MATERIALS REQUIRED:1   - Radio Shack mini-box ( #270-235)1   - 1/4 watt resistor, 2.2k-2.4k ohm      (RS #271-1325)1   - 75pf-100pf variable capacitor      (Hard to find)2   - F61a chassis-type coaxial      connectors (RS #278-212)12" - No. 12 solid copper wire12" - RG59 coaxial cable         ///INSTRUCTIONS///1.  Bare a length of No. 12 gauge solid copper wire and twist around a 3/8"nail or rod to form a coil of 9 turns.Elongate coil to a length of 1 1/2"inches and form right angle bends oneach end.2.  Solder the varible capacitor tothe coil. It doesn't matter where yousolder it, it still does the same job.The best place for it is in the centerwith the adjustment screw facing upwardNote: When it comes time to place coilin box, the coil must be insulated fromgrounding.  This can be done by crazy-glueing a piece of rubber to the bottomof the box, and securing the coil to it.3.  Tap coil at points 2 1/2 turns fromends of coil and solder to coaxialchassis connectors, bringing tap leadsthrough holes in chassis box.  Use aslittle wire as possible.4.  Solder resistor to center of coiland ground other end of resistor tochassis box, using solder lug and smallscrew.5.  Drill a 1/2" diameter hold in mini-box cover to permit adjustment of thevariable capacitor from the outside.Inspect the device for defects inworkmanship and place cover on mini-box.  Tighten securely.6.  Place device in line with existingcable on either side of the coverterbox and connect to television set withthe short piece of RG59 coaxial cable.Set television set to HBO channel.7.  Using a plastic screwdriver (non-matalic)adjust the varible capacitor until picturetunes in. Sit back, relax, and enjoy!!!